All productsPool Pro Hydrochloric Acid (also referred to as HCL) is used for lowering pH in Pool Water. Test pH weekly. The recommended range is between 7.2 and 7.6. If the pH is higher than 7.6, correct it by adding the Hydrochloric Acid as shown on the following table.
Never add Hydrochloric Acid when people are in the pool.
| Approximate amounts of Hydrochloric Acid used when the pH is high | ||||
| Volume of Pool Water | Below 7.2 | pH Grading 7.2 – 7.6 | 8.0 | 8.4 |
| 10,000 Lt 30,000 Lt 50,000 Lt 100,000 Lt | DO NOT USE ACID | RECOMMENDED RANGE | 110ml 320ml 540ml 1.1Lt | 180ml 540ml 900ml 1.8Lt |
DO NOT ADD MORE THAN 500ML AT ANY ONE TIME
General Instructions for adding Hydrochloric Acid
- When adding Hydrochloric Acid ensure that the product is mixed thoroughly with water remembering to always add acid to water, never add water to acid.
- Apply the mixed chemical to the surface of the pool water.
- Allow 2-3 hours mixing with the filter running before measuring pH again. Carry out minor adjustments as necessary. If unsure take a water sample to your Pool Pro Professional.
- Store in an upright and secure position in a cool, well ventilated place. Keep out of reach of children.
- Make sure you read all the instructions on the label.
- Do not allow Hydrochloric Acid to come in to contact with any other chemicals, metals, carbonates, or concentrated alkalis.
Safety Directions for handling Hydrochloric Acid
Avoid contact with skin and eyes. Do not inhale fumes as serious damage to respiratory tract may occur.
Hydrochloric acid will cause severe burns to skin and permanent damage to eyes. Wear rubber gloves, boots and safety goggles. This product is highly corrosive – Class 8 Dangerous Goods. Download the MSD sheet for further information.
